PROJECT OF THE WEEK - CRISS CROSS CARD

Hi everyone, I'm here with another project of the week for The House That Stamps Built.  

This week I thought I'd show you a card design that's an old favorite of mine.  It's super easy and makes great cards for special occasions. 

Here are the supplies you'll need to make this type of card.

1 sheet of 8.5 x 11 inch card stock for the base.
Designer paper of your choice cut 4x5.25.
glue and/or ScoreTape 
1 piece of card stock measuring 4x5 for inside mat
Stamps, embellishments of your choice

You first will cut your 8.5 x 11 inch card stock in half measuring over 5.50 inches on the 11 inch side.  You'll then have two pieces of CS each measuring 4.25 x 5.50.  (the size of an A2 card).  Score these pieces on the 8.5 inch side in half again at 4.25 inches.  

Next you'll place one of these cut pieces in your paper cutter making sure the scored fold point and the bottom corner of the cs are on an even diagonal.  This takes a little adjusting, however, it's important that each point is perfectly placed.  When you're ready, cut the angle off.  Repeat on the second portion of cs, on the opposite side.  

You should have two separate mirror images, as shown.  

Put score tape or glue of your choice on the back of one of the mirror images and then place it over the top of the other unglued piece up to, but not over the score line.  The two pieces should be flush on all edges.

Use a bone folder to press the folds down then grab your designer paper and place it in your paper cutter on the angle of corner to corner.  If you're using double sided paper for this, you only have to cut one piece of paper.  If you are using single sided paper you'll need to cut two pieces each in opposite direction.  

Adhere these pieces to each side of the base card where they fold.  

Next run a strip of glue or Score Tape along the bottom of the center of the base card and fold one of the side panels over it.  (you decide which side will be in the background and which one will be in the foreground).  

Next run some glue or tape along the bottom edge of the side panel you just adhered and seal that side.  Your card is now done and ready to decorate.  

RI Stamps used for this card are #9501-O "Wine Time", #9504-G "Wine Label" and #9515-G "Friends and Wine".  All from the Wine Time set.

This card uses RI Stamps #4321-J "Swan Love", #3904-H "To Love and Be Loved" and #1144-D "Happy Anniversary".  

Happy creating!!!